Replacing a thermal fuse once it has tripped is easy enough, but you need to recognize that it was tripped for a reason. Every time a thermal fuse trips, it has potentially saved your home and your life. While there are ways to bypass using a thermal fuse, it is highly recommended that it is replaced. Your fuse will easily come off and the new one can be installed. To replace the fuse, gently disconnect the two wires attached to it and unthread the mounting screw. If it still has continuity, you may want to look to the heating element itself. You can test the fuse for continuity with a multimeter to discover if it was the true cause. It is a small part about an inch in length that is connected via two wires. You will now have access to the thermal fuse located by the exhaust vent. Now once the dryer is unplugged and the exhaust hose is removed, unthread the screws that secure the back panel to remove it. You will also want to loosen the screws on the clamp that secures your dryer exhaust hose to your appliance so you can disconnect the hose. In order to reach the thermal fuse, you should start by disconnecting your dryer from the power via unplugging it. This is so it can accurately react when the temperature gets too high as all air needs to pass through the exhaust. While the location of the thermal fuse may vary from model to model, in most cases it is located by the dryer exhaust hose. Once the fuse is tripped, it will need to be replaced in order to get your dryer properly functioning again. Unfortunately, the thermal fuse is a part in your dryer that is only used a single time. Your clothes may come out a little drier after the cycle ends, but still significantly damp as well as cold to the touch. However, as no electricity is reaching the heating element, there will be no heat to efficiently dry your clothes. Your display lights still work, you can still start a cycle, and the drum will even still spin. In most models, your dryer will still work very much as it normally would. If your thermal fuse has been tripped, it can be easy to diagnose. However, dryer fires are far less common than they used to be thanks to one small part that is now required to be included in every newly manufactured dryer by federal law – the thermal fuse.Ī thermal fuse helps to protect appliance owners by detecting when a dryer becomes too hot and shutting off electricity to the heating element. Everyone has heard the horror stories of dryer fires that have caused extensive home damage and injuries.
0 kommentar(er)
